C and C++ SoftBench User's Guide

Using SoftBench Debugger

Handling Signals and Events

Chapter 7 215

Figure 7-13 "Intercepts" Dialog Box

SoftBench Debugger automatically creates intercepts for all signals and

events. Signal intercepts are all active, and other intercepts are

suspended. Highlight an intercept and select "Activate" to use it.

The buttons below the list allow you to modify the intercepts' attributes.

You can control four attributes for each intercept:

Status Controls whether the intercept is currently Active.

Select Suspend to deactivate an active intercept.

Report Type Controls whether SoftBench Debugger reports the

intercept in the Debugger I/O Area (Verbose) or

handles it Silently.

Count Speciﬁes how many times the intercept should be

ignored before SoftBench Debugger handles it.

Commands Speciﬁes the DDE command string (if any) to execute

when the intercept occurs. See "Help: DDE

Reference" for a description of these commands.

When you highlight an intercept, you can change any of the above

attributes and select OK or Apply to save the changes.

You can also Activate or Suspend all intercepts by choosing the buttons