P-UX SNAplus2 Installation Guide (June 2003)

Installation Requirements
SNAplus2 Link Hardware and Software Requirements
Chapter 124
HP 9000 Hardware
SNAplus2 Link requires the following HP 9000 hardware:
• An HP 9000 computer system (D, E, F, G, H, I, K, T, R, V, L, N-class
or Superdome server, or B, C, or J-class workstations)
• 18.9 MB of disk space
• A physical link to the SNA remote system, such as a pair of
compatible modems, a modem eliminator, or a LAN connection.
• A PSI card and available slot if using SDLC. Note that for
workstations, an EISA PSI upgrade kit might also be needed.
• A PCI card and available slot if using PCI SDLC. Note that PCI
SDLC is supported only on the HP 9000 L, N,V-class and Superdome
servers and the J-class workstations.
Running SNAplus2 Link in a client/server environment requires
additional LAN/9000 Link hardware components for servers or
workstations, including the LAN interface card.
Running SNAplus2 Link using QLLC requires X.25 hardware and
software.
Running SNAplus2 Link using Token Ring, 802.3/Ethernet, or FDDI
requires hardware for each link type.
HP 9000 Software
SNAplus2 Link requires HP-UX operating systems B.10. 20 or B.11.00
and later. Note that Superdome systems require the HP-UX 11i operating
system.
Running SNAplus2 Link in a client/server environment requires
additional LAN/9000 Link software components for servers and
workstations, including ARPA/Berkeley Sockets.
Running SNAplus2 Link using QLLC requires X.25 software.
Running SNAplus2 Link using Token Ring, 802.3/Ethernet, or FDDI
requires software for each link type.
Optional Running xsnapadmin, the configuration and management GUI, requires
the following:
• Motif interface software