HP-UX SNAplus2 Upgrade Guide (June 2003)
Changes in SNAplus2 Functions in R6.0 and later releases
RJE Workstations and RJE FCBs
Chapter 4 63
RJE Workstations and RJE FCBs
In R6.0 and later releases, the definition of RJE FCBs and much of the
definition of RJE workstations (including the printer and punch devices
associated with them) is held in an RJE workstation style file, rather
than in the configuration file as in SNAplus. For details of the contents of
this file, refer to the HP-UX SNAplus2 RJE Users Guide. The
environment variables used with RJE in SNAplus have also been
replaced by options in this file.
The configuration file migration tool creates a style file for each
workstation in the SNAplus configuration file. The name of the file is
wkstn
.sty, where
wkstn
is the name of the RJE workstation; it is
created in the same directory as the output configuration file. This file
does not contain a define_minor_options record; this record is set up
when you first run the workstation, as described in “Running RJE
Workstation for the First Time”.
On the RJE workstation, copy the style file to /etc/opt/sna if this was
not already done by the migration utility. The file's access permissions
must be one of the following:
• Ownership by either the primary user of the workstation or root,
with read access for the owner
• Group ownership by either the group configured for the workstation
or the SNAplus2 administration group, with read access for the
owner and group
The workstation cannot run unless this directory contains an RJE style
file with the appropriate name. (All other files and subdirectories
associated with the workstation are still created when the workstation is
first started, as in SNAplus.)
Running RJE Workstation for the First Time
The information in this section applies when running RJE workstations
for the first time after migrating the configuration to Release 6 or later.