HP-UX SNAplus2 Upgrade Guide (June 2003)

Changes in SNAplus2 Functions in R6.0 and later releases
NetView Commands and UNIX Command Facility
Chapter 456
Any output generated after the command
completes is not returned to UCF. For example, if
you issue a command followed by & to run it in the
background, UCF receives the operating system
message giving the process ID of the background
command, but does not receive any subsequent
output that may be generated. Similarly, you can
use UCF to start a daemon process, but you cannot
see any output generated by the process.
The format of the output messages from UCF has
been changed slightly.
For more information about SPCF and UCF, refer to
the chapter on managing SNAplus2 from NetView, in
the HP-UX SNAplus2 Administration Guide.