HP-UX SNAplus2 RJE User's Guide

SNAplus2 RJE Components and Operation
Getting Information About RJE Jobs
Chapter 372
------------------ 11:29:23 PDT 09 Apr 1996 ------------------
RJE Message 16389 - 63, Subcode: 55 - 1
Log category: AUDIT Cause Type: Audit
System: hpntcbf
Process ID: 3967 (snaprjestart)
RJE RJEF: Received host output on PUN2 device
Routed to program /opt/sna/bin//rjeusrpad
Size of output = 111 bytes
Filetype = PUNCH
Mode = TEXT
Cause: The workstation shown has successfully received data from the
host. The message shows the type of device to which the data is being
sent (printer, punch, or exchange), and either PRT (printer) or PUN
(punch) followed by the printer or punch number.
If output is being appended to a file, note that the output size shown is
the size of the complete file after the new data has been appended, not
the volume of data added.
------------------ 11:29:23 PDT 09 Apr 1996 ------------------
RJE Message 32770 - 83, Subcode: 0 - 1
Log category: AUDIT Cause Type: Audit
System: hpntcbf
Process ID: 4115 (rjeusrpad)
RJE: RJEF rjeusr/rjeusrpad has routed output for PUN2.
Output contains no usr card
Filename = /var/opt/sna/rje/RJEF/output/PUN0004
Cause: An output device was configured to do usr card routing by using
the rjeusr or rjeusrpad program. A usr card was not found in the
output, so the output file was not routed. The output is left in the file
specified with the message.
Action: If you want the output routed, use a usr card in the data. Consult
the HP-UX SNAplus2 RJE User’s Guide for information about the usr
card. If a usr card is used, the device must be configured to convert
EBCDIC data to ASCII in order for the usr card to be readable.
------------------ 12:58:31 PDT 09 Apr 1996 ------------------
RJE Message 32770 - 66, Subcode: 0 - 1
Log category: AUDIT Cause Type: Audit
System: hpntcbf
Process ID: 4148 (rjeusrpad)