HP-UX SNAplus2 Release Notes Version R7.11.31.300 (5992-5690, September 2012)

Optional
Running xsnapadmin, the configuration and management GUI, requires the following:
• Motif interface software
• Bit-mapped display to run X11
SNAplus2 APPN End Node
The SNAplus2 APPN End Node requires the same hardware and software as the SNAplus2 Link.
HP SNAplus2 APPN Enterprise Extender and NN
The HP SNAplus2 APPN Enterprise Extender and NN requires the same hardware and software
as the HP SNAplus2EE Link.
Installation requirements
After you determine that you have the hardware and software required for the SNAplus2 products
you are installing, you can begin loading the product files. Be sure to have a CD-ROM drive
attached to your system to read the product media. This drive should be configured on your system
with an entry in the /dev directory.
To load the product files into the appropriate directories on your system, use the /usr/sbin/swinstall
program. For specific instructions on using swinstall, refer to the HP Software Distribution Utilities
(SD) User’s Guide.
To add the SNAplus2 Environment and Link components, run the SAM SNAplus2 Installation
Program on the SAM “Networking and Communications” screen.
Defect fixes in this version
Table 1 Defects fixed in this version of SNAplus2
ProblemIdentifer
SNA:11.31 Crash in nlm_generate_actlu_rsp processing ACTLU after buffer shortage.QXCR1001200774
Software availability in native languages
This version of SNAplus2 is available only in English.
6 HP-UX SNAplus2 R7.11.31.300 Release Notes