HP-UX SNAplus2 Release Notes (June 2001)

HP-UX SNAplus2 R6.11.11.001 Release Note
Compatibility Information and Installation Requirements
Chapter 110
Running SNAplus2 Link using Token Ring, 802.3/Ethernet, or FDDI requires software for
each link type.
Optional
Running xsnapadmin, the configuration and management GUI, requires the following:
• Motif interface software
• bit-mapped display to run X11
SNAplus2 APPN End Node
The SNAplus2 APPN End Node requires the same hardware and software as the SNAplus2
Link.
Installation Requirements
After you determine that you have the hardware and software required for the SNAplus2
products you are installing, you can begin loading the product files. Be sure to have a
CD-ROM drive attached to your system to read the product media. This drive should be
configured on your system with an entry in the /dev directory.
To load the product files into the appropriate directories on your system, use the
/usr/sbin/swinstall program. For specificinstructions on using swinstall, refer to the HP
Software Distribution Utilities (SD) User’s Guide.
To add the SNAplus2 Environment and Link components, run the SAM SNAplus2
Installation Program on the SAM “Networking and Communications” screen.