HP-UX SNAplus2 R7 NOF Programmer's Guide

NOF Indications
LS_INDICATION
ls_stats.bad_xids
Total number of unsuccessful XID exchanges that have occurred on this link station since it was started.
tg_num
Transmission group number associated with the LS.
sense_data
If the LS has failed because of an XID protocol error, this parameter contains the sense data associated with
the error. If
indication_cause is set to any value other than
AP_FAILED, this parameter is reserved.
brnn_link_type
This parameter applies only if the local node is a Branch Network Node; it is reserved otherwise.
Specifies the branch link type of this link. Possible values are:
AP_UPLINK
The link is an uplink.
AP_DOWNLINK
The link is a downlink.
AP_OTHERLINK
The link is to a VRN.
AP_UNKNOWN_LINK_TYPE
The branch link type is unknown.
AP_BRNN_NOT_SUPPORTED
The link supports PU 2.0 traffic only.
adj_cp_is_brnn
Specifies whether the adjacent node is a Branch Network Node. Possible values are:
AP_YES
The adjacent node is a Branch Network Node.
AP_NO
The adjacent node is not a Branch Network Node.
AP_UNKNOWN
The adjacent node type is unknown.
ls_type
Specifies how this link was defined or discovered. Possible values are:
AP_LS_DEFINED
The link station was defined explicitly by a SNAplus2 administration program.
AP_LS_DYNAMIC
The link station was created when the local node connected to another node through a connection
network.
AP_LS_TEMPORARY
The link station was created temporarily to process an incoming call, but has not yet become active.
AP_LS_IMPLICIT
The link station was defined implicitly when SNAplus2 received an incoming call that it could not
match to a defined link station.
784