HP-UX SNAplus2 R7 NOF Programmer's Guide

NOF Indications
DLUR_PU_INDICATION
4.5.2 Parameters
opcode
AP_DLUR_PU_INDICATION
primary_rc
AP_OK
data_lost
Specifies whether any previous directory indications have been lost. If SNAplus2 detects a condition that
prevents it from sending an indication (for example an internal resource shortage), it indicates this by setting
the
data_lost parameter on the next indication after the condition has cleared. Possible values are:
AP_YES
One or more previous directory indications were lost. Later fields in this VCB may be set to zeros.
AP_NO
No previous directory indications were lost.
reason
Cause of the indication. Possible values are:
Possible values are:
AP_ACTIVATION_STARTED
The PU is activating.
AP_ACTIVATING
The PU has become active.
AP_DEACTIVATING
The PU has become inactive.
AP_FAILED
The PU has failed.
AP_ACTIVATION_FAILED
The PU has failed to activate.
pu_name
Name of the physical unit (PU). This is an 8-byte alphanumeric type-A EBCDIC string (starting with a letter),
padded on the right with EBCDIC spaces.
pu_id
PU identifier defined in a DEFINE_INTERNAL_PU verb or obtained in an XID from a downstream PU. This
value is a 4-byte hexadecimal string. Bits 0–11 are set to the Block number and bits 12–31 are set to the ID
number that uniquely identifies the PU.
pu_location
Location of the PU. Possible values are:
AP_INTERNAL
The PU has been defined by a DEFINE_INTERNAL_PU verb.
AP_DOWNSTREAM
The PU is located at a downstream computer.
pu_status
Status of the PU, as seen by the DLUR. Possible values are:
760