HP-UX SNAplus2 R7 NOF Programmer's Guide

NOF API Verbs
QUERY_PU
Origin Destination Assignor Indicator. When bringing up a session, the sender of the BIND sets this field
to zero if the local node contains the primary link station, and sets it to one if the BIND sender is the node
containing the secondary link station.
pu_data.pu_sscp_stats.ls_name
Link station name associated with statistics. This is an 8-byte ASCII character string, right-padded with
spaces if the name is shorter than 8 characters.
pu_data.pu_sscp_stats.pacing_type
The type of receive pacing in use on the PU-SSCP session. This parameter is set to
AP_NONE.
pu_data.sscp_id
For dependent LU sessions, this parameter is the SSCP ID received in the ACTPU from the host for the PU
to which the local LU is mapped. For independent LU sessions, this parameter is set to
0
(zero). This value
is an array of six bytes displayed as hexadecimal values.
pu_data.dddlu_supported
Specifies whether the host system supports DDDLU (Dynamic Definition of Dependent LUs). Possible values
are:
AP_YES
The host supports DDDLU.
AP_NO
The host does not support DDDLU.
pu_data.tcpcv_supported
Specifies whether the host system supports receiving TCP Control Vectors. A TN3270 Server can send a
TCP Control Vector to the host to indicate the IP address of the client it is serving.
Possible values are:
AP_YES
The host supports TCPCVs.
AP_NO
The host does not support TCPCVs.
pu_data.dddlu_offline_supported
Specifies whether the local PU supports sending NMVT (power off) messages to the host. If the host system
supports DDDLU (Dynamic Definition of Dependent LUs), SNAplus2 sends NMVT (power off) to the host
when it has finished using a dynamically defined LU. This allows the host to save resources by removing the
definition when it is no longer required.
Possible values are:
AP_YES
The local PU sends NMVT (power off) messages to the host.
AP_NO
The local PU does not send NMVT (power off) messages to the host.
3.150.4 Returned Parameters: Parameter Check
If the verb does not execute because of a parameter error, SNAplus2 returns the following parameters:
622