HP-UX SNAplus2 R7 NOF Programmer's Guide

NOF API Verbs
QUERY_LU_0_TO_3
AP_3270_DISPLAY_MODEL_2
AP_3270_DISPLAY_MODEL_3
AP_3270_DISPLAY_MODEL_4
AP_3270_DISPLAY_MODEL_5
AP_PRINTER
AP_SCS_PRINTER
AP_RJE_WKSTN
AP_UNKNOWN
lu_0_to_3_detail.def_data.sscp_id
Specifies the ID of the SSCP permitted to activate this LU. This is a 6-byte binary field. If this parameter is
set to binary zeros, the LU may be activated by any SSCP.
lu_0_to_3_detail.def_data.timeout
Timeout for the LU, specified in seconds. If a timeout is supplied and the user of the LU specified
allow_timeout on the OPEN_LU_SSCP_SEC_RQ (or, in the case of PU concentration, on the downstream
LU definition), then the LU will be deactivated after the PLU-SLU session is left inactive for this period and
one of the following conditions applies:
• The session passes over a limited resource link.
• Another application wishes to use the LU before the session is used again.
If the timeout is set to zero, the LU will not be deactivated.
lu_0_to_3_detail.def_data.term_method
This parameter specifies how SNAplus2 should attempt to end a PLU-SLU session to a host from this LU.
Possible values are:
AP_USE_NODE_DEFAULT
Use the node’s default termination method, specified by the send_term_self parameter on DE-
FINE_NODE.
AP_SEND_UNBIND
End the session by sending an UNBIND.
AP_SEND_TERM_SELF
End the session by sending a TERM_SELF.
3.131.4 Returned Parameters: Parameter Check
If the verb does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
AP_PARAMETER_CHECK
secondary_rc
Possible values are:
AP_INVALID_LU_NAME
The list_options parameter was set to AP_LIST_INCLUSIVE to list all entries starting from the
supplied name, but the lu_name parameter was not valid.
AP_INVALID_LIST_OPTION
The list_options parameter was not set to a valid value.
526