HP-UX SNAplus2 R7 NOF Programmer's Guide

NOF API Verbs
QUERY_LS
Primary
AP_LS_SEC
Secondary
AP_LS_NEG
Negotiable
ls_detail.def_data.max_ifrm_rcvd
Maximum of I-frames that can be received by this link station before an acknowledgment is sent. This value
is in the range
0–127. When this field is zero, the value of
max_ifrm_rcvd from DEFINE_PORT is used as
default.
ls_detail.def_data.dlus_retry_timeout
Interval in seconds between second and subsequent attempts to contact the DLUS specified in the
ls_detail.def_data.dlus_name and ls_detail.def_data.bkup_dlus_name parameters. The interval between the
initial attempt and the first retry is always one second. If zero is returned, the default value configured with
DEFINE_DLUR_DEFAULTS is used. This parameter is ignored if ls_detail.def_data.dspu_services is not set
to
AP_DLUR.
ls_detail.def_data.dlus_retry_limit
Maximum number of retries after an initial failure to contact the DLUS specified in the
ls_detail.def_data.dlus_name and ls_detail.def_data.bkup_dlus_name parameters. If zero is re-
turned, the default value configured through DEFINE_DLUR_DEFAULTS is used. If
0x0FFFF
is returned,
SNAplus2 retries indefinitely. This parameter is ignored if ls_detail.def_data.dspu_services is not set to
AP_DLUR.
ls_detail.def_data.branch_link_type
This parameter applies only if the local node is a Branch Network Node; it is reserved if the local node is
any other type.
If the parameter def_data.adj_cp_type is set to AP_NETWORK_NODE, AP_END_NODE, AP_APPN_NODE,or
AP_BACK_LEVEL_LEN_NODE, this parameter defines whether the link is an uplink or a downlink. Possi-
ble values are:
AP_UPLINK
The link is an uplink.
AP_DOWNLINK
The link is a downlink.
ls_detail.def_data.adj_brnn_cp_support
This parameter applies only if the local node is a Branch Network Node and the adjacent node is a network
node (the parameter def_data.adj_cp_type is set to AP_NETWORK_NODE, or it is set to AP_APPN_NODE and
the node type discovered during XID exchange is network node). It is reserved if the local and remote nodes
are any other type.
This parameter defines whether the adjacent node can be a Branch Network Node that is acting as a Network
Node from the point of view of the local node. Possible values are:
AP_BRNN_ALLOWED
The adjacent node is allowed (but not required) to be a Branch Network Node.
AP_BRNN_REQUIRED
The adjacent node must be a Branch Network Node.
AP_BRNN_PROHIBITED
510