HP-UX SNAplus2 R7 NOF Programmer's Guide

NOF API Verbs
DEFINE_LS
set to a single hex byte, which is 0xC3 to request that the called node supports the 1980 QLLC level, or
0xCB to request 1984 support. Some remote systems may require additional bytes; check with the System
Administrator of the remote system.
DLC-specific data for Token Ring, Ethernet, FDDI:
mux_info.dlc_type
Type of the DLC.
Possible values are:
AP_IMPL_TR_DLPI
Token Ring
AP_IMPL_ETHER_DLPI
Ethernet
AP_IMPL_FDDI_DLPI
FDDI
test_timeout
Timeout required before a TEST frame is retransmitted when trying to contact a remote station. The timer
is specified in milliseconds. Higher values may be needed if the remote station is on a separate Token Ring
connected by a bridge.
test_retry_limit
The TEST retry limit value corresponds to the number of times transmission and retransmission of a TEST
frame is allowed. This count includes the initial transmission; that is, a value of 1 indicates “transmit once
but do not retry”. Higher values may be needed if the remote station is on a separate Token Ring connected
by a bridge.
xid_timeout
Timeout required before an XID is retransmitted when trying to contact a remote station. The timer is specified
in milliseconds. Higher values may be needed if the remote station is on a separate Token Ring connected
by a bridge.
xid_retry_limit
The XID retry limit value corresponds to the number of times transmission and retransmission of an XID is
allowed. This count does not include the initial transmission; that is, a value of 1 indicates “transmit once and
then retry once”. Higher values may be needed if the remote station is on a separate Token Ring connected
by a bridge.
t1_timeout
Timeout required before an I-frame is retransmitted if no response is received. The timer is specified in
milliseconds. Higher values may be needed if the remote station is on a separate Token Ring connected by a
bridge.
Some systems may provide alternative methods of configuring the LLC2 stack, in which case this parameter
may be ignored; check with your SNAplus2 supplier.
t1_retry_limit
The T1 retry limit value corresponds to the number of times transmission and retransmission of an I-frame is
allowed. The minimum is 1. Higher values may be needed if the remote station is on a separate Token Ring
connected by a bridge.
Some systems may provide alternative methods of configuring the LLC2 stack, in which case this parameter
may be ignored; check with your SNAplus2 supplier.
188