HP-UX SNAplus2 R7 LUA Programmer's Guide

RUI Verbs

RUI_REINIT

lua_prim_rc

LUA_COMM_SUBSYSTEM_ABENDED

A required SNAplus2 software component (such as the node) has terminated or has been stopped.

Contact your System Administrator if necessary.

lua_prim_rc

LUA_SESSION_FAILURE

The LUA session has failed.

If the secondary return code is not

LUA_RUI_LOGIC_ERROR, then this LU can be reinitialized using an

RUI_REINIT. If it is not reinitialized, then an RUI_TERM must be issued before an RUI_INIT can be

issued for the same LU.

lua_sec_rc

Possible values are:

LUA_LU_COMPONENT_DISCONNECTED

The LUA session has failed because of a problem with the communications link or with the host LU.

LUA_RUI_LOGIC_ERROR

This return code indicates one of the following:

• The host system has violated SNA protocols

• An internal error was detected within LUA

Attempt to reproduce the problem with SNA tracing active (contact your System Administrator if

necessary), and check that the host is sending correct data. If this does not solve the problem, contact

your SNAplus2 support personnel.

lua_prim_rc

LUA_INVALID_VERB

Either the

lua_verb parameter or the lua_opcode parameter was not valid. The verb did not execute.

lua_prim_rc

LUA_UNEXPECTED_DOS_ERROR

An operating system error occurred.

lua_sec_rc

This value is the operating system return code. Check your operating system documentation for the meaning

of this return code.

4.6.3 Interaction with Other Verbs

This verb can only be issued if a previous LUA verb has returned with primary return code

LUA_SESSION_FAILURE,

and with a secondary return code other than

LUA_RUI_LOGIC_ERROR.

Until this verb has completed successfully, the only other LUA verb that can be issued for this session is RUI_TERM

(which will terminate a pending RUI_REINIT).

4.6.4 Usage and Restrictions

The RUI_REINIT verb completes after an ACTLU is received from the host. If necessary, the verb waits indeﬁnitely.

If an ACTLU has already been received prior to the RUI_REINIT verb, the verb returns immediately with primary

return code LUA_OK.