HP-UX SNAplus2 R7 Installation Guide

Installing SNAplus2 Client Software on Windows Clients

Installing Windows Client Software from the Command Line

Chapter 558

Installing Windows Client Software from the

Command Line

You can install the Windows client software from the command line

instead of using the Setup program through Windows. At the command

line, enter the setup command with one or more options. You can enter

these options in uppercase or lowercase, and can precede them with a /

(slash) or - (hyphen). If a parameter, such as

folder

, is a string that

contains a space, you must enclose the string inside double quotes.

After you enter the setup command, the Setup program prompts you for

any information you have not included on the command line, and

displays conﬁrmation messages at various stages of the setup. If you do

not want the Setup program to prompt you, use the -s option to run the

program in silent mode.

Following are the setup command options:

Display a list of the command line options. This is the

same as the -h option.

-h

Display a list of the command line options. This is the

same as the -? option.

-s

Run the installation in silent mode. The -s option must

be the last one in the command line, and you must be

sure you have speciﬁed all the required parameters.

When the installation runs in silent mode, it does not

prompt you for any parameters or display conﬁrmation

messages. Any command-line arguments after -s are

ignored.

-k

folder

Specify the Program folder.

-p