HP-UX SNAplus2 R7 Installation Guide

Verifying the SAM SNAplus2 Installation Process

Verifying your Installation

Chapter 3 29

Verifying your Installation

Before you follow the steps in this chapter, check the following:

• If you are using a QLLC link, make sure that X.25 is installed and

conﬁgured into your system.

• If you are using a Token Ring, FDDI or Ethernet make sure that this

link type is installed and conﬁgured into your system.

• If you are conﬁguring SDLC links, make sure that PSI cards are

installed (for PCI SDLC, you need a PCI card).

Under most circumstances, the kernel is generated automatically when

SNAplus2 installation is performed in SAM. If this does not happen,

check the following:

Step 1. Run /usr/sbin/swverify and investigate any errors.

Step 2. Use the /usr/sbin/swlist command to check that you have installed

all the SNAplus2 products.

Step 3. Save a copy of the system ﬁle you will be modifying (usually

/stand/system).

Step 4. Verify that the following statements are included in the system ﬁle

(default is /stand/system). Use the kmsystem command for each of the

drivers as follows:

kmsystem -q

driver_name

Verify that the “Conﬁgured” and “Loadable” ﬂags are “Y” and “N”

respectively for each of the conﬁgured drivers.