HP-UX SNAplus2 R7 Installation Guide

Installing SNAplus2

Loading SNAplus2 Product Files

Chapter 222

Loading SNAplus2 Product Files

After you determine that you have the hardware and software required

for the SNAplus2 products you are installing, you can begin loading the

product ﬁles. Be sure that you have a CD-ROM drive attached to your

system to read the product media. This drive should be conﬁgured on

your system with an entry in the /dev directory.

You will need to load the following product ﬁles for each product you

install:

To load the product ﬁles into the appropriate directories on your system,

use the /usr/sbin/swinstall program. For speciﬁc instructions on

loading the product ﬁles using swinstall, refer to the HP Software

Distribution Utilities (SD) Users Guide.

Once you have loaded the SNAplus2 product ﬁles, you can use the SD

command, swverify, to do the following:

• Verify whether SNAplus2 is compatible with the hosts on which the

software was installed.

• Verify that all dependencies (prerequisites) are being met for

installed software.

Table 2-1

SNAplus2 Products Product Files to Load

HP SNAplus2 Link SNAplus2-Link-R7

HP SNAplus2 3270 and 3179G SNAplus2-3270-R7

HP SNAplus2 API SNAplus2-API-R7

HP SNAplus2 RJE SNAplus2-RJE-R7

To add HP SNAplus2 Enterprise Extend

Netwk Node support to SNAplus2 Link

SNAplus2-NNEE-R7

Required ﬁles for all SNAplus2 products SNAplus2-Comn-R7

To add APPN End Node support to

SNAplus2 Link

SNAplus2-EN-R7