HP-UX SNAplus2 R7 APPC Programmer's Guide

TP Server Verbs
REJECT_ATTACH
opcode
AP_ACCEPT_ATTACH
tps_id
The ID of the TP server, as returned on a previous REGISTER_TP_SERVER verb.
attach_id
The ID of the attach, as returned by the attach notification callback.
5.6.3 Returned Parameters
After the verb executes, APPC returns parameters to indicate whether the execution was successful and, if not, to
indicate the reason the execution was not successful.
Successful Execution
If the verb executes successfully, APPC returns the following parameter:
primary_rc
AP_OK
Unsuccessful Execution
If the verb does not execute successfully, APPC returns a primary return code parameter to indicate the type of
error and a secondary return code parameter to provide specific details about the reason for unsuccessful execution.
Parameter Check
If the verb does not execute because of a parameter error, APPC returns the following parameters:
primary_rc
AP_PARAMETER_CHECK
secondary_rc
Possible values are:
AP_BAD_ATTACH_ID
The value specified for the attach_id parameter was not recognized.
AP_BAD_TPS_ID
The value specified for the tps_id parameter was not recognized.
Other Conditions
If the verb does not execute because other conditions exist, APPC returns the following primary return code. For a
list of return codes common to all verbs, see Appendix B, Common Return Codes.
primary_rc
AP_UNEXPECTED_SYSTEM_ERROR
5.7 REJECT_ATTACH
The REJECT_ATTACH verb is used to end the processing of the attach by this TP server.
261