HP-UX SNAplus2 R7 APPC Programmer's Guide

APPC Conversation Verbs
MC_SEND_ERROR and SEND_ERROR
secondary_rc
AP_BO_NO_RESYNC
AP_BO_RESYNC
primary_rc
AP_PROG_ERROR_PURGING
APPC does not return a secondary return code with this primary return code.
The following return code can be generated only if the MC_SEND_ERROR verb is issued in Send state:
primary_rc
AP_DEALLOC_ABEND
APPC does not return a secondary return code with this primary return code.
The following return codes can be generated only if the SEND_ERROR verb is issued in Send state:
primary_rc
AP_DEALLOC_ABEND_PROG
AP_DEALLOC_ABEND_SVC
AP_DEALLOC_ABEND_TIMER
AP_SVC_ERROR_PURGING
APPC does not return secondary return codes with these primary return codes.
4.17.6.2.3.3 Verb Issued in Receive State
The following return code can be generated only if the verb is issued in Receive state:
primary_rc
AP_DEALLOC_NORMAL
APPC does not return a secondary return code with this primary return code.
4.17.7 State When Issued
The conversation can be in any state except Reset when the TP issues this verb.
4.17.8 State Change
The new state is determined by the primary return code primary_rc. Possible state changes are summarized in the
following table.
primary_rc
New state
AP_OK
Send (half-duplex conversation), or no change
(full-duplex conversation)
AP_PARAMETER_CHECK
AP_CONVERSATION_TYPE_MIXED
AP_INVALID_VERB
AP_INVALID_VERB_SEGMENT
AP_STACK_TOO_SMALL
AP_TP_BUSY
AP_UNEXPECTED_DOS_ERROR
No change
AP_ALLOCATION_ERROR
Reset
AP_CONV_FAILURE_RETRY
AP_CONV_FAILURE_NO_RETRY
Reset
231