HP-UX SNAplus2 R7 Administration Guide

Defining Connectivity Components
Defining DLCs, Ports, and Connection Networks
• 1 (300 baud)
• 2 (600 baud)
• 3 (1200 baud)
• 4 (2400 baud)
• 5 (4800 baud)
• 6 (9600 baud)
• 7 (19200 baud)
For example, you can specify a 9600 baud rate dial string by entering (6), as follows:
(6)AT &&D3 &&Q1 DT7,012345678
For an explanation of the rest of the dial string, refer to your modem’s documentation.
For switched outgoing ports, the dial string is configured on each link station. For leased ports, this
field does not apply.
Consult your SNA network planner if you do not know how to configure any of these parameters.
Additional Port Parameters for Token Ring, FDDI and Ethernet
Local SAP number
The address of the SAP, usually 04. Use a different value only if you need to use more than one SAP on
the card.
The SAP number must be a multiple of 4.
If you do not know what value to enter for this field, contact your SNA network planner.
Define on connection network
Whether the SAP is to access the LAN as a connection network. Defining a connection network enables links
between nodes on the connection network to be started dynamically, without prior configuration.
This field applies only if the local node is not a LEN node, because LEN nodes cannot use connection
networks.
CN name
The name of the connection network. You do not need to enter the CN name unless you specified the Define
on connection network option to define the SAP on a connection network. The CN name is used as the name
of a virtual routing node in order to establish links between the nodes on the connection network.
Specify the same CN name on all nodes on the connection network.
Ethernet type
This field applies only to Ethernet links.
Whether the network is a standard Ethernet network or an IEEE 802.3 network.
Additional Port Parameters for X.25 (QLLC)
Match incoming X.25 address
The link address of the remote station (only needed if you want to restrict incoming data traffic). If you supply
this value, incoming call packets are accepted only if they specify an address that starts with the configured
address.
89