HP-UX SNAplus2 R7 Administration Command Reference

Administration Commands
define_internal_pu
secondary_rc
NO_SECONDARY_RC
primary_rc
UNSUCCESSFUL
secondary_rc
Possible values are:
IMPLICIT_REQUEST_REJECTED
The specified focal point rejected the request.
IMPLICIT_REQUEST_FAILED
The node could not send the request to the specified focal point; this may be because the specified
control point or application was not found.
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
2.30 define_internal_pu
The define_internal_pu command defines a PU on the local node that is served by DLUR. (To define a
downstream PU served by DLUR or PU concentration, or to define a local PU that is directly attached to the host,
use define_*_ls (for the appropriate link type) instead of define_internal_pu.)
2.30.1 Supplied Parameters
Parameter name Type Length Default
[define_internal_pu]
pu_name character 8
description character 31 (null string)
dlus_name character 17 (null string)
bkup_dlus_name character 17 (null string)
pu_id hex array 4
initially_active constant NO
dlus_retry_timeout decimal (0)
dlus_retry_limit decimal (0)
dddlu_offline_supported constant NO
Supplied parameters are:
pu_name
Name of the internal PU to be defined. This name is a type-A character string starting with a letter.
This name should match the PU name configured on the host. (SNAplus2 sends both the PU name and PU
ID to the host to identify the PU. The host normally identifies the PU by its PU name, or by the PU ID if it
cannot find a matching PU name.)
description
A text string describing the internal PU. SNAplus2 uses this string for information only. It is stored in the
node’s configuration file and returned on the query_dlur_pu and query_pu commands.
dlus_name
96