HP-UX SNAplus2 R7 Administration Command Reference

Administration Commands

deﬁne_dspu_template

STATE_CHECK

secondary_rc

Possible values are:

INVALID_PU_NAME

The speciﬁed dspu_name parameter value was not valid.

PU_NOT_DEFINED

The speciﬁed dspu_name parameter did not match any deﬁned PU name.

INVALID_PU_TYPE

The PU speciﬁed by the dspu_name parameter is not a downstream PU that supports PU concentration.

LU_ALREADY_DEFINED

An LU has already been deﬁned with a name that matches one of the names in the range. The existing

LU cannot be modiﬁed using this command.

DSLU_ACTIVE

An LU with a name that matches one of the names in the range is already active. The existing LU

cannot be modiﬁed using this command.

LU_NAU_ADDR_ALREADY_DEFD

An LU has already been deﬁned with an NAU address that matches one of the addresses in the range.

INVALID_HOST_LU_NAME

The speciﬁed host_lu_name parameter value was not valid.

LU_NAME_POOL_NAME_CLASH

One of the LU names in the range matches the name of an existing LU pool.

Function Not Supported

If the command does not execute because the node’s conﬁguration does not support it, SNAplus2 returns the

following parameters:

primary_rc

FUNCTION_NOT_SUPPORTED

The local node does not support PU concentration; this support is deﬁned by the pu_conc_support

parameter on the

define_node command.

secondary_rc

(This parameter is not used.)

Other Conditions

Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary

return codes that are common to all commands.

2.21 deﬁne_dspu_template

The define_dspu_template command deﬁnes a template for the downstream LUs that use the SNAplus2 PU

concentration feature. This template is used to deﬁne downstream LUs on a group of downstream workstations

when a workstation connects over an implicit link (a link not previously deﬁned)..