HP-UX SNAplus2 R7 Administration Command Reference

Administration Commands
define_downstream_lu_range
The specified dspu_name parameter did not match any defined PU name.
INVALID_PU_TYPE
The PU specified by the dspu_name parameter is not a downstream PU that supports PU concentration.
LU_ALREADY_DEFINED
An LU with the name specified by the dslu_name parameter has already been defined, and cannot be
modified using this command.
DSLU_ACTIVE
The LU is already active.
LU_NAU_ADDR_ALREADY_DEFD
An LU with the NAU address specified by the nau_address parameter has already been defined.
INVALID_HOST_LU_NAME
The specified host_lu_name parameter value was not valid.
LU_NAME_POOL_NAME_CLASH
The specified LU name matches the name of an existing LU pool.
PU_NOT_ACTIVE
The PU specified by the dspu_name parameter is not currently active.
LU_ALREADY_ACTIVATING
An LU with the name specified by the dslu_name parameter is currently activating.
LU_DEACTIVATING
An LU with the name specified by the dslu_name parameter is currently deactivating.
LU_ALREADY_ACTIVE
An LU with the name specified by the dslu_name parameter is already active.
Function Not Supported
If the command does not execute because the node’s configuration does not support it, SNAplus2 returns the
following parameters:
primary_rc
FUNCTION_NOT_SUPPORTED
The local node does not support PU concentration; this support is defined by the pu_conc_support
parameter on the define_node command.
secondary_rc
(This parameter is not used.)
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
2.20 define_downstream_lu_range
The define_downstream_lu_range command defines a range of new downstream LUs and maps them to
an upstream host LU or LU pool. This command cannot be used to modify existing downstream LUs.
82