HP-UX SNAplus2 R7 Administration Command Reference

Administration Commands
define_cos
PROP_DELAY_PKT_SWITCHED_NET
Delay is in the range 50–250 microseconds (typical for a packet-switched network).
PROP_DELAY_SATELLITE
Delay is greater than 250 microseconds (typical for a satellite link).
PROP_DELAY_MAXIMUM
Maximum propagation delay.
min_user_def_parm_1 through min_user_def_parm_3
Minimum limits for user-defined parameters, which you can use to include TG characteristics not
covered by previously defined parameters. Each of these parameters must be set to a value in the range
0–255.
max_effect_cap
Maximum limit for actual bits per second rate (line speed). Specify a value in the range 0–
603,979,776,000.
max_connect_cost
Maximum limit for cost per connect time. Valid values are integer values in the range 0–255, where
0 is the lowest cost per connect time and 255 is the highest cost per connect time.
max_byte_cost
Maximum limit for cost per byte. Valid values are integer values in the range 0–255, where 0 is the
lowest cost per byte and 255 is the highest cost per byte.
max_security
Maximum level of security. Possible values are:
SEC_NONSECURE
Data is transmitted over an unsecured network.
SEC_PUBLIC_SWITCHED_NETWORK
Data is transmitted over a public-switched network.
SEC_UNDERGROUND_CABLE
Data is transmitted over secure underground cable.
SEC_SECURE_CONDUIT
Data is transmitted over a line in a secure conduit that is not guarded.
SEC_GUARDED_CONDUIT
Data is transmitted over a line in a conduit that is protected against physical tapping.
SEC_ENCRYPTED
Data is encrypted before transmission over the line.
SEC_GUARDED_RADIATION
Data is transmitted over a line that is protected against physical and radiation tapping.
max_prop_delay
Maximum limits for propagation delay, which is the time that a signal takes to travel the length of the
link. Specify one of the following values, according to the type of link:
67