HP-UX SNAplus2 R7 Administration Command Reference

Administration Commands
query_userid_password
Parameter Check
No parameter errors occur for this command.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands,
occur for this command.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
2.180 query_userid_password
The query_userid_password command returns information about user ID / password pairs for use with APPC
and CPI-C conversation security, or about profiles for a defined user ID and password. This command can be used
to obtain information about a specific user ID / password pair or about multiple pairs, depending on the options
used.
2.180.1 Supplied Parameters
Parameter name Type Length Default
[query_userid_password]
num_entries decimal 1
list_options constant LIST_INCLUSIVE
user_id character 10 (null string)
Supplied parameters are:
num_entries
Maximum number of user ID / password pairs for which data should be returned. You can specify 1 to return
data for a specific user ID / password pair, a number greater than 1 to return data for multiple user ID /
password pairs, or 0 to return data for all user ID / password pairs.
list_options
The position in the list of user ID / password pairs from which SNAplus2 begins to return data.
Possible values are:
FIRST_IN_LIST
Start at the first entry in the list
LIST_INCLUSIVE
Start at the entry specified by the user_id parameter
LIST_FROM_NEXT
Start at the entry immediately following the entry specified by the user_id parameter
user_id
User ID for which information is required or the user ID to be used as an index into the list of user ID/
password pairs. This ID is a type-AE character string. The user ID is ignored if list_options is set to
FIRST_IN_LIST.
570