HP-UX SNAplus2 R7 Administration Command Reference

Administration Commands
query_tn3270_defaults
The list_options parameter was set to LIST_INCLUSIVE, but the display LU specified in the
display_lu_name parameter did not match any existing association.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands,
occur for this command.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
2.173 query_tn3270_defaults
The query_tn3270_defaults command returns information about TN3270 parameters used on all client
sessions, as defined on define_tn3270_defaults.
2.173.1 Supplied Parameters
[query_tn3270_defaults]
No parameters are supplied for this command.
2.173.2 Returned Parameters
Parameter Type Length
force_responses constant
keepalive_method constant
keepalive_interval decimal
If the command executes successfully, SNAplus2 returns the following parameters:
force_responses
Controls client responses on printer sessions. Possible values are:
YES
Request definite responses.
NO
Request responses matching SNA traffic.
keepalive_method
Method for sending keep-alive messages. Keep-alive messages are messages sent to TN3270 clients when
there is no other activity on the connection, to keep the TCP/IP connections to the clients active; this ensures
that failed connections and clients can be detected. If there is no traffic at all on a TCP/IP connection, failure
of the connection or of the client may never be detected, which wastes TN server resources and prevents LUs
from being used for other sessions.
Possible values are:
NONE
Do not send keep-alive messages.
NOP
557