HP-UX SNAplus2 R7 Administration Command Reference

Administration Commands
query_session
Returns the conversation duplex support as negotiated on the BIND. Possible values are:
HALF-DUPLEX
Only half-duplex conversations are supported.
FULL_DUPLEX
Both full-duplex and half-duplex sessions are supported. Expedited data is also supported.
sscp_id
For dependent LU sessions, this parameter is the SSCP ID received in the ACTPU from the host for the PU
to which the local LU is mapped. For independent LU sessions, this parameter is set to
0
(zero).
session_start_time
The time between the CP starting and this session becoming active, measured in one-hundredths of a second.
If the session is not fully active when the query is processed, this parameter is set to
0 (zero).
session_timeout
The timeout associated with this session. This timeout is derived from:
• The LU 6.2 timeout associated with the local LU
• The LU 6.2 timeout associated with the remote LU
• The mode timeout
• The global timeout
• The limited resource timeout (if this session is running over a limited resource link)
2.168.4 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a
secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
INVALID_LU_ALIAS
The lu_alias parameter value was not valid.
INVALID_LU_NAME
The lu_name parameter value was not valid.
INVALID_SESSION_ID
The list_options parameter was set to LIST_INCLUSIVE to list all entries starting from the supplied
name, but the session_id parameter value was not valid.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands,
occur for this command.
536