HP-UX SNAplus2 R7 Administration Command Reference

Administration Commands
query_node
secondary_rc
(This parameter is not used.)
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
2.155 query_node
The query_node command returns information about the definition of a SNAplus2 node and also on its status if
it is active. This command returns information only about a single node. To obtain a list of nodes in the SNAplus2
domain, use the command query_node_all; you can then use query_node for an individual node in this list
to obtain more detailed information.
2.155.1 Supplied Parameters
[query_node]
No parameters are supplied for this command.
2.155.2 Returned Parameters
Parameter name Type Length
description character 31
node_type constant
fqcp_name character 17
cp_alias character 8
mode_to_cos_map_supp constant
mds_supported constant
node_id character 4
max_locates decimal
dir_cache_size decimal
max_dir_entries decimal
locate_timeout decimal
reg_with_nn constant
reg_with_cds constant
mds_send_alert_q_size decimal
cos_cache_size decimal
tree_cache_size decimal
tree_cache_use_limit decimal
max_tdm_nodes decimal
max_tdm_tgs decimal
max_isr_sessions decimal
isr_sessions_upper_threshold decimal
isr_sessions_lower_threshold decimal
isr_max_ru_size decimal
isr_rcv_pac_window decimal
store_endpt_rscvs constant
store_isr_rscvs constant
store_dlur_rscvs constant
dlur_support constant
pu_conc_support constant
nn_rar decimal
481