HP-UX SNAplus2 R7 Administration Command Reference

Administration Commands
query_nn_topology_stats
Function Not Supported
If the command does not execute because the node’s configuration does not support it, SNAplus2 returns the
following parameters:
primary_rc
FUNCTION_NOT_SUPPORTED
The local node is an end node or LEN node. This command is valid only for a network node.
secondary_rc
(This parameter is not used.)
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
2.153 query_nn_topology_stats
The query_nn_topology_stats command returns statistical information about the topology database. The
command can be used only if the SNAplus2 node is a network node and is not valid if it is an end node or LEN
node.
This command must be issued to a running node.
2.153.1 Supplied Parameters
[query_nn_topology_stats]
No parameters are supplied for this command.
2.153.2 Returned Parameters
Parameter name Type
max_nodes decimal
cur_num_nodes decimal
node_in_tdus decimal
node_out_tdus decimal
node_low_rsns decimal
node_equal_rsns decimal
node_good_high_rsns decimal
node_bad_high_rsns decimal
node_state_updates decimal
node_errors decimal
node_timer_updates decimal
node_purges decimal
tg_low_rsns decimal
tg_equal_rsns decimal
tg_good_high_rsns decimal
tg_bad_high_rsns decimal
tg_state_updates decimal
tg_errors decimal
tg_timer_updates decimal
471