HP-UX SNAplus2 R7 Administration Command Reference
Administration Commands
query_ls
Possible values are:
YES
The local PU sends NMVT (power off) messages to the host.
NO
The local PU does not send NMVT (power off) messages to the host.
If the host supports DDDLU but does not support the NMVT (power off) message, this parameter must be
set to
NO.
initially_active
Specifies whether this LS is automatically started when the node is started. Possible values are:
YES
The LS is automatically started when the node is started.
NO
The LS is not automatically started; it must be manually started.
restart_on_normal_deact
Specifies whether SNAplus2 should attempt to reactivate the LS if it is deactivated normally by the remote
system. Possible values are:
YES
If the remote system deactivates the LS normally, SNAplus2 attempts to reactivate it, using the same
retry timer and count values as for reactivating a failed LS (the react_timer and react_timer_retry
parameters above).
NO
If the remote system deactivates the LS normally, SNAplus2 does not attempt to reactivate it.
If the LS is a host link (specified by the adj_cp_type parameter), or is automatically started when the node is
started (the initially_active parameter is set to YES), this parameter is ignored; SNAplus2 always attempts to
reactivate the LS if it is deactivated normally by the remote system (unless react_timer_retry is zero).
react_timer
Reactivation timer for reactivating a failed LS. If the react_timer_retry parameter is a nonzero value (to specify
that SNAplus2 should retry activating the LS if it fails), this parameter specifies the time in seconds between
retries. When the LS fails, or when an attempt to reactivate it fails, SNAplus2 waits for the specified time
before retrying the activation. If react_timer_retry is
0
(zero), this parameter is ignored.
react_timer_retry
Retry count for reactivating a failed LS. This parameter is used to specify whether SNAplus2 should attempt
to reactivate the LS if it fails while in use (or if an attempt to start the LS fails).
A value of
0 (zero) indicates that SNAplus2 does not attempt to reactivate the LS. A value of
65,535 indicates
that SNAplus2 retries indefinitely until the LS is reactivated.
SNAplus2 waits for the time specified by the react_timer parameter between successive retries. If the LS is
not successfully reactivated by the end of the retry count, or if stop_ls is issued while SNAplus2 is retrying
the activation, no further retries are made; the LS remains inactive unless start_ls is issued for it.
If the auto_act_supp parameter is set to YES, the react_timer and react_timer_retry parameters are ignored; if
the link fails, SNAplus2 does not attempt to reactivate it until the user application that was using the session
attempts to restart the session.
address
428