HP-UX SNAplus2 R7 Administration Command Reference

Administration Commands
query_local_topology
End node (EN) or low-entry networking (LEN) node
tg_num
Number associated with the TG.
dlc_data
If dest_type is VRN, this parameter specifies the DLC address of the connection to the VRN. The number of
bytes in the address depends on the DLC type. This parameter is not used otherwise.
For Token Ring, Ethernet, or FDDI, the address is in two parts: a 6-byte MAC address and a 1-byte local
SAP address. The bit ordering of the MAC address may not be in the expected format. For information about
converting between the two address formats, see Bit ordering in MAC addresses in Section 2.60, define_tr_ls,
define_ethernet_ls, define_fddi_ls.
rsn
Resource sequence number assigned by the owning network node.
status
Specifies the status of the TG. Possible values (which can be combined with a + character) are:
TG_OPERATIVE
Transmission group link is operative.
TG_CP_CP_SESSIONS
Transmission group link between CP-CP sessions.
TG_QUIESCING
Transmission group link is quiescing.
TG_HPR
Transmission group supports High Performance Routing (HPR) protocols.
TG_RTP
Transmission group supports Rapid Transport Protocol (RTP).
effect_cap
through user_def_parm_3
TG characteristics. For more information about these parameters, see Section 2.60, define_tr_ls, de-
fine_ethernet_ls, define_fddi_ls.
cp_cp_session_active
Specifies whether the owning node’s contention winner CP-CP session is active. Possible values are:
YES
The CP-CP session is active.
NO
The CP-CP session is not active.
UNKNOWN
The CP-CP session status is unknown.
branch_link_type
This parameter applies only if the node is a Branch Network Node; it is reserved otherwise.
Specifies the branch link type of this TG. Possible values are:
UPLINK
The TG is an uplink.
DOWNLINK
406