HP-UX SNAplus2 R7 Administration Command Reference

Administration Commands
query_default_pu
PARAMETER_CHECK
secondary_rc
Possible values are:
NAME_NOT_FOUND
The server specified by the dest_sys parameter was not valid or was not started.
LOCAL_SYSTEM
The server specified by the dest_sys parameter is the same as the target node to which this command
was issued.
INVALID_TARGET
The command was issued on a standalone server. This command can only be issued on a client-server
system.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands,
occur for this command.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
2.116 query_default_pu
The query_default_pu command returns information about the default PU, which is defined using de-
fine_default_pu.
2.116.1 Supplied Parameters
[query_default_pu]
No parameters are supplied for this command.
2.116.2 Returned Parameters
Parameter name Type Length
def_pu_name character 8
description character 31
def_pu_sess character 8
If the command executes successfully, SNAplus2 returns the following parameters:
def_pu_name
Name of the most recently defined default PU. This parameter is blank if no default PU has been defined or
the default PU has been deleted.
description
A text string describing the default PU, as specified in the definition of the default PU.
def_pu_sess
334