HP-UX SNAplus2 R7 Administration Command Reference

Administration Commands
define_sdlc_ls
INVALID_BRNN_SUPPORT
The adj_brnn_cp_support parameter was not set to a valid value.
BRNN_SUPPORT_MISSING
The adj_brnn_cp_support parameter was set to ALLOWED; this value is not valid because the adjacent
node is a Network Node and auto_act_supp is set to YES.
INVALID_UPLINK
The branch_link_type parameter was set to UPLINK, but the definition of an existing LS between the
local and adjacent nodes specifies that it is a downlink. The branch link type must be the same for all
LSs between the same two nodes.
INVALID_DOWNLINK
The branch_link_type parameter was set to DOWNLINK, but the definition of an existing LS between
the local and adjacent nodes specifies that it is an uplink. The branch link type must be the same for
all LSs between the same two nodes.
State Check
If the command does not execute because of a state error, SNAplus2 returns the following parameters:
primary_rc
STATE_CHECK
secondary_rc
Possible values are:
DUPLICATE_CP_NAME
The CP name specified in the adj_cp_name parameter has already been defined.
DUPLICATE_DEST_ADDR
The destination address specified in the address parameter has already been defined.
INVALID_LINK_NAME
The link station value specified in the ls_name parameter was not valid.
INVALID_NUM_LS_SPECIFIED
The number of link stations specified was not valid.
LOCAL_CP_NAME
The value specified in the adj_cp_name parameter was the same as the local CP name.
LS_ACTIVE
The link station specified in the ls_name parameter is currently active.
PU_ALREADY_DEFINED
The PU specified in the pu_name parameter has already been defined.
DSPU_ALREADY_DEFINED
The downstream PU specified in the dspu_name parameter has already been defined.
DSPU_SERVICES_NOT_SUPPORTED
PU_CONCENTRATION or DLUR has been specified on the dspu_services parameter, but the node does
not support it.
DUPLICATE_TG_NUMBER
The TG number specified in the tg_number parameter has already been defined.
TG_NUMBER_IN_USE
197