HP-UX SNAplus2 R7 Administration Command Reference

Administration Commands
define_sdlc_ls
HNA
Hitachi Network Architecture host
SUPPRESS_CP_NAME
Suppress the CP name associated with the remote node. Use a + character to combine this value with
SNA, FNA,orHNA.
If adj_cp_type is set to BACK_LEVEL_LEN_NODE, and the remote LEN node associated with this LS cannot
accept the Network Name CV in the format 3 XID it receives, use a + character to combine the value SNA,
FNA,orHNA with SUPPRESS_CP_NAME (for example, SNA+SUPPRESS_CP_NAME).
If adj_cp_type is set to any other value, the SUPPRESS_CP_NAME option is ignored.
adj_node_id
Node ID of adjacent node. This ID is a 4-byte hexadecimal string, consisting of a block number (three
hexadecimal digits) and a node number (five hexadecimal digits). To disable node ID checking, do not
specify this parameter. If this link station is defined on a switched port, the adj_node_id must be unique, and
there may only be one null adj_node_id on each switched port.
local_node_id
Node ID sent in XIDs on this LS. This ID is a 4-byte hexadecimal string, consisting of a block number (three
hexadecimal digits) and a node number (five hexadecimal digits). To use the node ID specified in the node_id
parameter on the define_node command, do not specify this parameter.
cp_cp_sess_support
Specifies whether CP-CP sessions are supported. This parameter is valid only if the adjacent node is an
end node or a network node (adj_cp_type is NETWORK_NODE, END_NODE,orLEARN_NODE); it is ignored
otherwise. If both the local node and the adjacent node are network nodes, this parameter should be set to
YES in order to use APPN functions between these nodes.
Possible values are:
YES
CP-CP sessions are supported. The solicit_sscp_sessions parameter must be set to NO.
NO
CP-CP sessions are not supported.
use_default_tg_chars
Specifies whether to use the default TG characteristics supplied on define_sdlc_port. The TG
characteristics apply only if the link is to an APPN node. If the link is not to an APPN node, the
use_default_tg_chars through user_def_parm_3 parameters are ignored. Possible values are:
YES
Use the default TG characteristics; ignore the effect_cap through user_def_parm_3 parameters on this
command.
NO
Use the effect_cap through user_def_parm_3 parameters on this command.
effect_cap
A decimal value representing the line speed in bits per second.
connect_cost
Cost per connect time. Valid values are integer values in the range 0–255, where 0 is the lowest cost per
connect time and 255 is the highest cost per connect time.
188