HP-UX SNAplus2 R7 Administration Command Reference

Administration Commands
define_rtp_tuning
path_switch_attempts decimal 6
short_req_retry_limit decimal 6
path_switch_time_low decimal 480
path_switch_time_medium decimal 240
path_switch_time_high decimal 120
path_switch_time_network decimal 60
Supplied parameters are:
path_switch_attempts
Number of path switch attempts to set on new RTP connections. Specify a value in the range 1–255.
short_req_retry_limit
Number of times a Status Request is sent before SNAplus2 determines that an RTP connection is disconnected
and starts Path Switch processing. Specify a value in the range 1–255.
path_switch_time_low
Length of time in seconds for which SNAplus2 attempts to path switch a disconnected RTP connection with
transmission priority set to
AP_LOW. Specify a value in the range 1–65535.
path_switch_time_medium
Length of time in seconds for which SNAplus2 attempts to path switch a disconnected RTP connection with
transmission priority set toAP_MEDIUM. Specify a value in the range 1–65535. The value you specify must
not exceed the value of
path_switch_time_low.
path_switch_time_high
Length of time in seconds for which SNAplus2 attempts to path switch a disconnected RTP connection with
transmission priority set toAP_HIGH. Specify a value in the range 1–65535. The value you specify must not
exceed the value for any lower transmission priority.
path_switch_time_network
Length of time in seconds for which SNAplus2 attempts to path switch a disconnected RTP connection with
transmission priority set toAP_NETWORK. Specify a value in the range 1–65535. The value you specify must
not exceed the value for any lower transmission priority.
2.49.2 Returned Parameters
No parameters are returned by SNAplus2 when this command executes successfully.
2.49.3 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a
secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
INVALID_PATH_SWITCH_TIMES
One or more of the specified path switch times was not valid; for example, you may have specified a
value for one transmission priority that exceeds the value specified for a lower transmission priority.
178