HP-UX SNAplus2 R7 Administration Command Reference

Administration Commands
define_qllc_port
2.46 define_qllc_port
The define_qllc_port command is used to define a new QLLC port or modify an existing QLLC port. Before
issuing this command, you must define the DLC that this port uses.
You can modify an existing port only if it is not started. You cannot change the DLC used by an existing port; the
dlc_name specified when modifying an existing port must match the DLC that was specified on the initial definition
of the port.
For information about defining a port that will accept incoming calls, see Section 2.46.4, Incoming Calls.
2.46.1 Supplied Parameters
Parameter name Type Length Default
[define_qllc_port]
port_name character 8
description character 31 (null string)
dlc_name character 8
port_number decimal 1
max_rcv_btu_size decimal 265
tot_link_act_lim decimal 64
inb_link_act_lim decimal 0
out_link_act_lim decimal 0
ls_role constant LS_NEG
implicit_dspu_template character 8 (null string)
implicit_ls_limit decimal 0
implicit_dspu_services constant NONE
implicit_deact_timer decimal 30
act_xid_exchange_limit decimal 9
nonact_xid_exchange_limit decimal 5
ls_xmit_rcv_cap constant LS_TWS
max_ifrm_rcvd decimal 7
target_pacing_count decimal 7
max_send_btu_size decimal 265
address character 15 (null string)
implicit_cp_cp_sess_support constant YES
implicit_limited_resource constant NO
implicit_hpr_support constant NO
implicit_uplink_to_en constant NO
effect_cap decimal 9600
connect_cost decimal 0
byte_cost decimal 0
security constant SEC_PUBLIC_SWITCHED_NETWORK
prop_delay constant PROP_DELAY_PKT_SWITCHED_NET
user_def_parm_1 decimal 0
user_def_parm_2 decimal 0
user_def_parm_3 decimal 0
initially_active constant YES
cud_mode constant DONTCARE
cud_match hex array 16 (null string)
add_mode constant DONTCARE
add_len decimal 0
vc_type constant SVC
loc_packet constant DEFAULT
rem_packet decimal DEFAULT
loc_wsize decimal 0
rem_wsize decimal 0
167