HP-UX SNAplus2 R7 Administration Command Reference

Administration Commands
define_node
Send an UNBIND on receipt of a CLOSE_PLU_SLU_SEC_RQ.
disable_branch_awareness
This parameter applies only if node_type is NETWORK_NODE; it is reserved for other node types.
Specify whether the local node supports branch awareness, APPN Option Set 1120, using one of the following
values:
YES
The local node does not support branch awareness. TGs between this node and served Branch Network
Nodes do not appear in the network topology, and the local node does not report itself as being branch
aware.
NO
The local node supports branch awareness.
cplu_syncpt_support
Specifies whether the node’s Control Point LU supports Syncpoint functions. This parameter is equivalent
to the syncpt_support parameter on define_local_lu, but applies only to the node’s Control Point LU
(which does not have an explicit LU definition).
Set this parameter to YES only if you have a Sync Point Manager (SPM) and Conversation Protected Resource
Manager (C-PRM) in addition to the standard SNAplus2 product. Possible values are:
YES
Syncpoint is supported.
NO
Syncpoint is not supported.
cplu_attributes
Identifies additional information about the node’s Control Point LU. This parameter is equivalent to the
lu_attributes parameter on define_local_lu, but applies only to the node’s Control Point LU (which
does not have an explicit LU definition).
Possible values are:
NONE
No additional information identified.
DISABLE_PWSUB
Disable password substitution support for the control point LU. Password substitution means that
passwords are encrypted before transmission between the local and remote LUs, rather than being
sent as clear text. SNAplus2 normally uses password substitution if the remote system supports it.
This value is provided as a work-around for communications with some remote systems that do not
implement password substitution correctly. If you use this option, you should be aware that this involves
sending and receiving passwords in clear text (which may represent a security risk). Do not set it unless
there are problems with the remote system’s implementation of password substitution.
dlur_support
Specifies whether DLUR is supported. For a LEN node, this parameter is reserved. Possible values are:
YES
DLUR is supported.
LIMITED_MULTI_SUBNET
143