HP-UX SNAplus2 R7 Administration Command Reference

Administration Commands
define_lu_pool
Either basic or enhanced verification is accepted.
2.38.2 Returned Parameters
No parameters are returned by SNAplus2 when this command executes successfully.
2.38.3 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a
secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
INVALID_LU_ALIAS
The lu_alias parameter did not match any defined LU alias.
INVALID_LU_NAME
The lu_name parameter did not match any defined local LU name.
INVALID_PLU_NAME
The fqplu_name parameter did not match any defined partner LU name.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands,
occur for this command.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
2.39 define_lu_pool
The define_lu_pool command is used to define an LU pool and assign LUs to it, or to assign additional LUs
to an existing pool. The LUs must be defined before adding them to the pool. You can also define a pool by
specifying the pool name when defining an LU. For more information, see Section 2.36, define_lu_0_to_3.
Do not use this command to remove LUs from an existing LU pool. Use delete_lu_pool to remove LUs and
change the LU pool definition.
2.39.1 Supplied Parameters
Parameter name Type Length Default
[define_lu_pool]
pool_name character 8
131