HP-UX SNAplus2 R7 Administration Command Reference

Administration Commands
define_local_lu
secondary_rc
Possible values are:
PORT_ACTIVE
The specified port cannot be modified because it is currently active.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
2.33.4 Incoming Calls
If you are configuring a port that accepts incoming calls (as defined by the tot_link_act_lim, inb_link_act_lim, and
out_link_act_lim parameters), there is no need to define an LS to use for these calls; SNAplus2 will dynamically
define an LS when the incoming call is received.
When an incoming call arrives at the port, SNAplus2 checks the address specified on the call against the addresses
specified for link stations defined on the port (if any) to determine if an LS has already been defined for the call. If
the address does not match, an LS is dynamically defined. To ensure that the explicit LS definition is used, be sure
that the address defined for this LS matches the address that is supplied by the remote computer on the incoming
call.
2.34 define_local_lu
The define_local_lu command defines a new local LU. The command can also be used to modify the disable,
description, sys_name, timeout,orback_level parameters for an existing LU or for the default LU associated with
the local node’s control point, but it cannot modify any of the other parameters. When modifying an existing LU,
all the other parameters that cannot be modified must be set to their currently defined values.
2.34.1 Supplied Parameters
Parameter name Type Length Default
[define_local_lu]
lu_name character 8
description character 31 (null string)
list_name character 14 (null string)
lu_alias character 8
nau_address decimal 0
syncpt_support constant NO
lu_session_limit decimal 0
default_pool constant NO
pu_name character 8 (null string)
lu_attributes constant NONE
sscp_id decimal 0
disable constant NO
sys_name character 128 (null string)
timeout decimal 60
back_level constant NO
Supplied parameters are:
lu_name
116