HP-UX SNAplus2 R7 Administration Command Reference

Administration Commands
define_ip_ls
State Check
If the command does not execute because of a state error, SNAplus2 returns the following parameters:
primary_rc
STATE_CHECK
secondary_rc
DLC_ACTIVE
A parameter cannot be modified because the DLC is currently active.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary
return codes that are common to all commands.
2.32 define_ip_ls
The define_ip_ls command is used to define a new link station (LS) for Enterprise Extender (HPR/IP), or
modify an existing one. Before issuing this command, you must define the port that this LS uses.
You cannot use this command to modify the port used by an existing LS; the name of the port specified in the
port_name parameter for this command must match the previous definition of the LS. The LS can be modified only
if it is not started.
2.32.1 Supplied Parameters
Parameter name Type Length Default
[define_ip_ls]
ls_name character 8
description character 31 (null string)
port_name character 8
adj_cp_name character 17 (null string)
adj_cp_type constant LEARN_NODE
lsap_address decimal 4
auto_act_supp constant NO
tg_number decimal 0
limited_resource constant NO
disable_remote_act constant NO
link_deact_timer decimal 30
default_nn_server constant NO
ls_attributes constant SNA
adj_node_id hex array 4
local_node_id hex array 4
cp_cp_sess_support constant YES
use_default_tg_chars constant YES
effect_cap decimal 9600connect_cost decimal
byte_cost decimal 0
security constant SEC_NONSECURE
prop_delay constant PROP_DELAY_MINIMUM
user_def_parm_1 decimal 0
user_def_parm_2 decimal 0
user_def_parm_3 decimal 0
target_pacing_count decimal 7
101