HP-UX SNAplus2 NOF Programmer's Guide

NOF API Verbs (ACTIVATE_SESSION to OPEN_FILE)
DEFINE_LS
Chapter 3286
network, set this parameter to zero. Check with the
administrator of your X.25 network to determine the
correct value to use.
rem_packet
Packet size used for receiving data from the remote
station. The actual size used is 2 to the power of
rem_packet (as for loc_packet above). To indicate
using the default packet size for the network, set this
parameter to zero. Check with the administrator of
your X.25 network to determine the correct value to
use.
loc_wsize
Window size used for sending data from the local
station to the remote station. Specify a value in the
range 1-7, or zero to indicate using the default window
size for the network. Check with the administrator of
your X.25 network to determine the correct value to
use.
rem_wsize
Window size used for receiving data from the remote
station. Specify a value in the range 1-7, or zero to
indicate using the default window size for the network.
Check with the administrator of your X.25 network to
determine the correct value to use.
fac_len
Length of the additional X.25 facilities data that
follows (in the fac parameter). If no additional data is
required, specify zero. If the X.25 network does not
support facilities negotiation, specify zero and see the
fac parameter below for more information.
fac
If the X.25 provider software is configured to allow flow
control negotiation, SNAplus2 includes information
about reverse charging options, packet sizes, and
window sizes in the facilities data sent to the remote
system. If your X.25 network or the remote system
requires any other facilities data in addition to the