HP-UX SNAplus2 NOF Programmer's Guide

NOF API Verbs (ACTIVATE_SESSION to OPEN_FILE)
DEFINE_LS
Chapter 3 279
def_data.dlus_retry_timeout
Reactivation timer for contacting a DLUS. If SNAplus2
fails to contact the DLUS, this parameter specifies the
time in seconds between retries.
Specify a value in the range 0x0001-0xFFFF.
def_data.dlus_retry_limit
The interval in seconds between the second and
subsequent attempts to contact the DLUS specified by
the dlus_name and bkup_dlus_name parameters.
Specify a value in the range 0x0001-0xFFFE, or specify
0xFFFF to indicate that SNAplus2 should retry
indefinitely until it contacts the DLUS. The interval
between the first and second attempts is always 1
second. If zero is specified, then the defaults specified
using the DEFINE_DLUR_DEFAULTS verb are used.
This parameter is ignored if the dspu_services
parameter is not set to AP_DLUR.
def_data.link_spec_data_len
Length of the link-specific data. The data should be
concatenated to the basic structure.
Link-specific data for SDLC:
mux_info.dlc_type
Type of the DLC. Set this to AP_IMPL_SDLC_SL
contact_timer
Timeout required before a SNRM or XID is
retransmitted in the event of nonacknowledgment
(used for primary SDLC only). This value must be
greater than the no response (T1) timeout value
no_resp_timer described below. The timer is specified
in milliseconds.
This timer is also used for special pre-activation
polling.
contact_timer_retry