HP-UX SNAplus2 NOF Programmer's Guide

NOF API Verbs (ACTIVATE_SESSION to OPEN_FILE)
DEFINE_LS
Chapter 3278
Maximum propagation delay.
def_data.tg_chars.user_def_parm_1 through
def_data.tg_chars.user_def_parm_3
User-defined parameters, which you can use to include
other TG characteristics not covered by the above
parameters. Each of these parameters must be set to a
value in the range 1-255.
def_data.target_pacing_count
Numeric value between 1 and 32,767 inclusive
indicating the desired pacing window size. (The current
version of SNAplus2 does not make use of this value.)
def_data.max_send_btu_size
Maximum BTU size that can be sent from this link
station. This value is used to negotiate the maximum
BTU size that a pair of link stations can use to
communicate with each other. The value includes the
length of the TH and RH (total 9 bytes) as well as the
RU. Specify a value in the range 265-65,535 (265-4105
for SDLC).
def_data.ls_role
Link station role. This is normally set to
AP_USE_PORT_DEFAULTS, specifying that the LS role is
to be taken from the definition of the port that owns
this LS.
If you need to override the port's LS role for an
individual LS, specify one of the following values:
AP_LS_PRI Primary
AP_LS_SEC Secondary
AP_LS_NEG Negotiable
def_data.max_ifrm_rcvd
The maximum number of I-frames that can be received
by this link station before an acknowledgment is sent.
Specify a value in the range 0-127.If0 is specified, the
value from DEFINE_QLLC_PORT
DEFINE_SDLC_PORTis used.