HP-UX SNAplus2 NOF Programmer's Guide

NOF API Verbs (ACTIVATE_SESSION to OPEN_FILE)
DEFINE_LS
Chapter 3 261
AP_UINT32 linesp; /* line speed in bps */
AP_UINT16 rcv_pool_size; /* initial number of buffers for */
/* rcv pool */
AP_UINT16 poll_wait; /* seconds between polling HMOD */
/* for errors */
AP_UINT16 hmod_data_len; /* length of dial data string */
unsigned char hmod_data[64]; /* dial data string */
unsigned char x21_sequence[255]; /* reserved */
unsigned char x21_retry_count; /* reserved */
AP_UINT16 x21_retry_delay; /* reserved */
AP_UINT16 v25_tx_delay; /* reserved */
unsigned char cdstl; /* reserved */
unsigned char reserve1[3]; /* reserved */
} STUB_SPEC_DATA;
DLC-specific data for QLLC:
typedef struct vql_ls_spec_data
{
V0_MUX_INFO mux_info; /* streams config info */
AP_UINT16 reserve1; /* reserved */
AP_UINT16 reserve2; /* reserved */
unsigned char vc_type; /* Virtual Circuit type */
unsigned char req_rev_charge; /* request reverse charge if */
/* non-zero */
unsigned char loc_packet; /* loc->rem packet */
/* size 2**locpacket */
unsigned char rem_packet; /* rem->loc packet */
/* size 2**rempacket */
unsigned char loc_wsize; /* loc->rem window size */
unsigned char rem_wsize; /* rem->loc window size */
AP_UINT16 fac_len; /* X.25 facilities length */
unsigned char fac[32]; /* X.25 facilities */
AP_UINT16 retry_limit; /* times to retry send QXID,QSM, */
/* QDISC */
AP_UINT16 retry_timeout; /* timeout for each of above tries*/
AP_UINT16 idle_timeout; /* timeout for no Q msgs during */
/* init */
AP_UINT16 pvc_id; /* PVC logical channel identifier */
AP_UINT16 sn_id_len; /* Length of the subnet identifier*/
unsigned char sn_id[4]; /* Subnet identifier */
AP_UINT16 cud_len; /* length of any call user data */
/* to send */
unsigned char cud[16]; /* actual call user data */
AP_UINT32 xtras; /* reserved */
AP_UINT32 xtra_len; /* reserved */
unsigned char rx_thruput_class; /* reserved */
unsigned char tx_thruput_class; /* reserved */
unsigned char cugo; /* reserved */
unsigned char cug; /* reserved */