HP-UX SNAplus2 MS Programmer's Guide

Management Services Verbs
CONNECT_MS_NODE
Chapter 352
owns a direct connection to the NetView host (the node
whose PU-SSCP session is used to transmit NMVTs to
the NetView program). For more information about
NMVT-level programs, see Chapter 1, “Introduction to
Management Services.”
If any of the following conditions is true, you can set
this parameter to all binary zeros (you do not need to
specify the node name):
• SNAplus2 is running with all components on a
single HP-UX computer (not on a LAN).
• The SNAplus2 LAN contains only one server.
• The application is MDS-level and will be sending
and receiving data in MDS_MU format and not in
NMVT format.
When the SNAplus2 LAN has multiple servers and
this parameter is set to all binary zeros, the application
will be connected to the node on the same server as the
application, if available, or to any other available node.
Returned Parameters
After the verb executes, SNAplus2 returns parameters to indicate
whether the execution was successful. If the verb execution was
successful, SNAplus2 also returns a target handle that the application
uses on subsequent MS entry points. If the verb execution was not
successful, SNAplus2 returns parameters to indicate the reason the
execution was not successful.
Successful Execution
If the verb executes successfully, SNAplus2 returns the following
parameters:
primary_rc
AP_OK
secondary_rc
Not used.
target_handle