HP-UX SNAplus2 Installation Guide (February 2007)

The terminfo Database
Altering the terminfo Database
Chapter 4 43
• \A = Select Alternate Character Set (if supported by term)
• \B = Bold Character (if terminal supports Bold)
• \D = Dim Character (if terminal supports Dim)
• \I = Inverse Character (if terminal supports Inverse)
• \S = Standout Character (Curses determines bold or inverse)
• \\ = The “\” character
• \: = The “:” character when “:” is last in the line
NOTE All Keywords after “\:” are ignored, therefore if “\:” is necessary in an
entry, then they must be the last characters in the line.
The maximum line length is 500 characters.
All lines beginning with “#” are considered comments.
Lines must not be broken; however, multiple entries are supported.
Examples
The following are hp2392 terminals with thin-line drawing character set.
The first entry is an example of how multiple entries can be used to
shorten the line length.
2392=hpSNAplus:UR=\At:UL=\Ar:BL\Af:BR=\Ag:HB=\A,
2392=hpSNAplus:LT=\A5:RT=\A6:S=\A):EL=\D\I:VB=\A.
2392a=hpSNAplus:UR=\At:UL=\Ar:BL=\Af:BR=\Ag:HB=\A,:LT=\A5:RT=\
A6:SB=\A):EL=\D\I:VB=\A.
2392A=hpSNAplus:UR=\At:UL=\Ar:BL=\Af:BR=\Ag:HB=\A,:LT=\A5:RT=\
A6:SB=\A):EL=\D\I:VB=\A
hp2392=hpSNAplus:UR=\At:UL=\Ar:BL=\Af:BR=\Ag:HB=\A,:LT=\A5:RT=
\A6:SB=\A):EL=\D\I:VB=\A
hp2392A=hpSNAplus:UR=\At:UL=\Ar:BL=\Af:BR=\Ag:HB=\A,:LT=\A5:RT
=\A6:SB=\A):EL=\D\I:VB=\A
The following are hp700/92 terminals with thick line-drawing character
set (notice “\:” is last)
70092=hpSNAplus:UR=\Aw:UL=\Aq:BL=\Aa:BR=\As:HB=\A;:LT=\A1:RT=\
A2:SB=\A):EL=D\I:VB=\A\: