HP-UX SNAplus2 Installation Guide (February 2007)

Verifying the SMH SNAplus2 Installation Process

Verifying your Installation

Chapter 3 33

Verifying your Installation

Before you follow the steps in this chapter, check the following:

• If you are using a QLLC link, make sure that X.25 is installed and

configured into your system.

• If you are using Ethernet make sure that this link type is installed

and configured into your system.

• If you are configuring SDLC links, make sure that PSI cards are

installed (for PCI SDLC, you need a PCI card (J2535A)).

Under most circumstances, the kernel is generated automatically when

SNAplus2 installation is performed in SMH. If this does not happen,

check the following:

Step 1. Run /usr/sbin/swverify and investigate any errors.

Step 2. Use the /usr/sbin/swlist command to check that you have installed

all the SNAplus2 products.

Step 3. Save a copy of the system file you will be modifying (usually

/stand/system).

Step 4. Verify that the following statements are included in the system file

(default is /stand/system). Use the kcmodule command for each of the

drivers as follows:

kcmodule -

v modulename

erify that the State field is “static” for each of the configured drivers.