HP-UX SNAplus2 Diagnostics Guide

Using snapfilter and snaptrcfmt
Formatting Internal Binary Trace Output into Text Files
Appendix A112
you must specify -c before -s .
-s components
Do not display a column in the drawing for one or more
individual components. Any messages flowing to or
from these components are shown in the “unknown”
column, so you can view detailed information without
having to display all the components in a group. For
example, you can view the PS and HS components but
suppress the RM component.
Specify each component by using the two-character
component identifiers as listed in “Message Flow
Drawing”. To specify multiple components, separate
them with commas.
NOTE Specify component groups with the —c option, but individual
components with the —s option.
If you use both of the options -c and -s , you must
specify -c before -s .
-p nn
Use a page length of nn lines for the message flow
drawing ( nn is a decimal number). SNAplus2 separates
pages with a page break character and includes the
column headers at the top of each page.
Do not specify both of the options -p and -P . If you
do not use either option, the default is -p 66.
-P
Produce output as a single page (no page breaks and
column headers only at the start of the data).
Do not specify both of the options -p and -P . If you
do not use either option, the default is -p 66.
Output from the snaptrcfmt Utility
The snaptrcfmt utility generates text output in either or both of the
following formats: