HP-UX SNAplus2 CSV Programmer's Guide

Common Service Verbs Reference
DEFINE_TRACE (HP-UX Systems Only)
Chapter 2 55
SNAplus2 checks only the most significant bit (bit 0) of
this byte; other bits are ignored.
To enable or disable tracing for the NOF API,
depending on the dt_set parameter, set the most
significant bit of this byte to 1.
To leave tracing in its current state for the NOF API,
set the most significant bit of this byte to zero.
comm_serv Specifies whether the state of tracing for the Common
Service Verbs (on or off) is to be changed.
SNAplus2 checks only the most significant bit (bit 0) of
this byte; other bits are ignored.
To enable or disable tracing for Common Service Verbs,
depending on the dt_set parameter, set the most
significant bit of this byte to 1.
To leave tracing in its current state for Common
Service Verbs, set the most significant bit ofthis byte to
zero.
ehllapi Specifies whether the state of HLLAPI tracing (on or
off) is to be changed. (HLLAPI tracing can also be
controlled using the TRON/TROFF options on the
HLLAPI Set Session Parameters function. For more
information, refer to the HP-UX SNAplus2 3270 &
TN3270 HLLAPI Programmers Guide.)
SNAplus2 checks only the most significant bit (bit 0) of
this byte; other bits are ignored.
To enable or disable tracing for HLLAPI, depending on
the dt_set parameter, set the most significant bit of
this byte to 1.
To leave tracing in its current state for HLLAPI, set
the most significant bit of this byte to zero.
ms Specifies whether the state of MS API tracing (on or
off) is to be changed.
SNAplus2 checks only the most significant bit (bit 0) of
this byte; other bits are ignored.