HP-UX SNAplus2 CPI-C Programmer's Guide (June 2003)

CPI-C Calls
Send_Error (cmserr)
Chapter 3226
CM_OPERATION_NOT_ACCEPTED See Appendix A,
“Common Return Codes.”
CM_PROGRAM_PARAMETER_CHECK The value specified by
conversation_ID is not valid.
CM_PROGRAM_STATE_CHECK The conversation state is
not Send, Receive, Confirm,
Confirm-Send,Confirm-Deallocate,or
Send-Pending.
State When Issued
The conversation can be in any state except Initialize,
Initialize-Incoming, or Reset.
State Change
The new state is determined by the return_code parameter. Possible
state changes are summarized in Table 3-13, “State Changes for the
Send_Error Call.”
Table 3-13 State Changes for the Send_Error Call
return_code New state
CM_OK Send
CM_CONVERSATION_TYPE_MISMATCH
CM_PIP_NOT_SPECIFIED_CORRECTLY
CM_SECURITY_NOT_VALID
CM_SYNC_LEVEL_NOT_SUPPORTED_PGM
CM_SYNC_LEVEL_NOT_SUPPORTED_LUCM_TP
N_NOT_RECOGNIZED
CM_TP_NOT_AVAILABLE_NO_RETRY
CM_TP_NOT_AVAILABLE_RETRY
Reset
CM_RESOURCE_FAILURE_RETRY
CM_RESOURCE_FAILURE_NO_RETRY
Reset
CM_DEALLOCATED_ABEND
CM_DEALLOCATED_ABEND_SVC
CM_DEALLOCATED_ABEND_TIMER
Reset
CM_DEALLOCATED_NORMAL Reset